analog liquid level sensor or electronic float to regulate liquid level in aquariums or tanks or ponds.

analog liquid level sensor or electronic float to regulate liquid level is easy to install, accurate and safe detects liquid changes of about 15 and 20mm

analog liquid level sensor or electronic float to adjust liquid level can also be considered as a reed sensor level switch contained in plastic material, while the float contains a small magnet that closes activates the sensor. In the aquarium, this analog liquid level sensor or electronic float is used to adjust the liquid level to monitor evaporation, and if connected--through a small but adequate circuit--to a small pump in the water supply, it helps replenish evaporated water

The electronic mechanical float is used to keep an eye on the level of liquids inside tanks, ponds or aquariums. It consists of an expanded polypropylene float that moves-as the liquid level changes-over a cylindrical body inside of which is a magnetic contact. When the liquid reaches the preset level, the contact changes state allowing a signal to be sent to the control system. The analog liquid level sensor or electronic float can comenad only constant current (DC) voltages not exceeding 1 A.

It is recommended to use a 12V transformer and the float switch to control a small centrifugal or peristaltic pump of the same voltage

FEATURES

• type: N.O. (normally open) or N. C. (normally closed)-to change the type, you remove the block and turn the float switch
• Maximum current: 1 A
• Maximum power: 10 VA
• Contact resistance (max): 150 mΩ
• Contact material: rhodium
• Response time: 0.6 ms / 0.1ms max.
• Maximum voltage: 100 Vdc
• Maximum peak voltage: 110 Vdc
• Working temperature: 0 - 70 °C
• Material: expanded polypropylene, polyamide
• Cable length at exposed terminals: 500 mm
• The total stroke is 8 mm
• The trigger is about 5 mm
• The diameter of the sensor is is 24 mm